MATERIALS

Skin Color Nako Diamond Code: 6730

Lanoso Alara Yellow 979

Lanoso Alara White 955

Lanoso Alara Dark blue 993

Lanoso Alara Light pink 933

Lanoso Alara Dark pink 978

10mm eye (honey color in the sample)

2.5 mm crochet

Bead fiber

HEAD
 (Rope: nako diamond, code: 6730,10889)

1. 6 frequent needles into the magic ring.
2. Double to each pin (12)
3. (1 pin, 1 increase) 6 times again (18)
4. (2 needles, 1 increase) 6 times again (24)
5. (3 needles, 1 increase) 6 times again (30)
6. (4 pins, 1 increase) 6 times again (36)
7. (5 needles, 1 increase) 6 times again (42)
8. (6 pins, 1 increase) 6 times again (48)
   9-16. row spacing: (48 pins)
9. 12 pins, (1 pin, 1 increase) 4 times again, 7 pins (nose part), (1 pin, 1 increase) 4 times again, 13 pins (56) = Meanwhile, 4 pins on the cheeks, ie 8 pins in total we’re going)
   18-21. row spacing: (56 pins)
   !!! Wear the eyes (10mm) between 15-16 rows so that they can be seen up to 5 pins. Note the part where we make the cheek enhancements here.
10. In the meantime, we decrease the 4 pins we have increased on the cheeks, as we have increased from the places corresponding to the same alignment. So we’re gonna drop 8 tight pins in total (48 tight pins)
11. (6 pins, 1 subtract) 6 times again (42)
12. (5 pins, 1 subtract) 6 times again (36)
13. (4 pins, 1 subtract) 6 times again (30)
14. (3 pins, 1 subtract) 6 times again (24)
15. (2 needles, 1 subtract) 6 times again (18)
16. (1 pin, 1 sub) 6 times again (12)
    (In my babies, especially the head parts are filled with fiber carefully, the fiber should be evenly distributed everywhere and the head should be full in order to avoid collapses over time. I do not completely close the head loops, I use plastic pipes or electric cables etc. to stand upright between the neck and the head. even if you plant it correctly, even if you don’t use anything, this doll will not fall because it is not too big (about 30cm) 🙂

WIG (thread lanoso alara)

1. 6 frequent needles into the magic ring.
   2nd . Double to each pin (12)
2. (1 pin, 1 increase) 6 times again (18)
3. (2 needles, 1 increase) 6 times again (24)
4. (3 needles, 1 increase) 6 times again (30)
5. (4 pins, 1 increase) 6 times again (36)
6. (5 needles, 1 increase) 6 times again (42)
7. (6 pins, 1 increase) 6 times again (48)
   9-14. row spacing: (48 pins)
8. (15 needles, 1 increase) Repeat 3 times (51)
   16-17. 51 tight
9. 10 tight needles, 1 single handrail, 1 double handrail (increase), 12 double handrails, 1 single handrail, 1 loop shift, 1 single handrail, 12 double handrails, 1 double handrail (increase), 1 single handrail, 9 tight needles (increase) we tie it with loop slide and cut the thread)

HAIR KNOB (2 pieces)

1. 6 frequent needles into the magic ring.
   2nd . Double to each pin (12)
2. (1 pin, 1 increase) 6 times again (18)
3. (2 needles, 1 increase) 6 times again (24)
    (3 needles, 1 increase) 6 times again (30)
   6-9. between rows: 30 pins
4. (3 needles, 1 subtract) 6 times again (24)
5. (2 pins, 1 subtract) 6 times again (18)
6. (1 pin, 1 sub) 6 times again (12)
   — Fill the inside and cut the thread (the tip will remain open). Fix it with a pin and sew to the head.
   If you want, you can make this knob bigger and use it as a single head.

FION:

Pull together 20 chains. Pull 3 chains and make 20 double handrails. You can fold the center of the rope long and sew it to the bun after a few wraps. (You can also use a ribbon as a hair bow. Checkered, scored ribbons look very stylish too.)

SHOES (2 Pieces)
(I prefer a thicker thread in shoes and socks than the body. My thread- Lanoso Alara blue code: 993)
Pull 1.7 chain

1. Starting from 2 chains, turn around the chain by making 6 tight needles. (Total: will be with 12 pins)
2. Increase the shoes by 3 on the front and back. (Total: will be with 18 pins) (I fold the base of the shoe in my hand to make these increments and deletions fully centered. If you do so, you will see the knot that corresponds exactly and with your increment-decrements, the shoe stays in good shape :))
3. Increase the shoes by 3 on the front and back. (Total: will be with 24 pins)
   5-6. row: 24 pins (knit the length of the shoe string and knit the sock, then make a chain tape on the front part)
4. Change to socks color. Subtract 6 loops from the front of the shoe (Total: 18 will be with the needle) – pay attention to the average!
5. Decrease 3 loops from the floor to the front of the shoes (Total: 15 will be with the needle)
   9-12. row: (15 pins)
6. Sock ruffle: Pull 2 ​​chains, turn the shoe in your hand and move in the opposite direction. (We will knit the front part of the flo shaped loops!) Pull the 2 chains and connect them with a loop shift. Finish the entire queue like this.

LEG

1. (Change to skin color) Knit 15 loops in the form of blo, taking the loops behind the part we knit in the upper part of the sock.
2. Make 14 pins (subtract 1 from the back)
   16-33. row spacing: knit 14 needles

BODY

1. (With white color) Assemble by pulling 4 chains between the two legs. (36 pins)
2. Increase 1 loop of stitches on both sides (38 pins)
   36 to 44 rows: 38 pins
   Between 45-46 rows (with skirt color) 38 pins
3. (If you are going to use a different color in the upper body, switch to that color) Knit only the back loops with the Blo technique. (38 tight needles) – Our dress skirt will start down from this section we knit as a block.
   48 to 50 rows: Continue the outfit by making color transitions as desired. I used 1 row of colors between 2 rows of white. It can be made in one color. (38 pins)
4. Decrease one stitch under the arms. (36)
   52-57. between rows: Come until 24 loops by reducing one stitch under the arms.
5. After filling the arms, add the arms to the body with 3-4 stitches in combination with the body with the loop sliding method (24 pins).

 
!!! The inner part of the arms filled with fiber will be closed because you close it while knitting with a crochet hook.
!!! You should put very little fiber on the upper part of the arms to keep it close to the body. Otherwise, the arms will be in the air.

1. (1 pin, 1 sub) 6 times again (18)
2. Collar Brush: Pull 2 ​​chains and turn the body in your hand and move in the opposite direction. (We will knit the front part of the flo shaped loops.) Pull the 2 chains and connect them with a loop shift. Finish the entire row in this way (as in the stocking ruffle). You can do the same method on the arm ends.
3. (Change to skin color) Knit the remaining loops (18 needles)
   62-64. row: Neck: (18 pins)
   You can cut the rope. Fix the neck with a pin to the head to cover the head gap, and sew it by taking a loop from a neck, a head. Plastic stick, cable, etc. between the body and head can be used to keep the head upright)

HANDLES (2 pieces)

1. 6 frequent needles into the magic ring (with skin color)
2. (1 pin, 1 increase) Repeat 3 times (9)
   3-6. row: 9 pins
   7-22th place: 9 pins (with color of clothes)
   You can cut the rope

 SKIRT
Begin the 47th row of the 1st size by sliding a loop with a skirt color. Make 2 double handrails to each loop by pulling 3 chains (76 double handrails)

1. Complete the entire row as (1 double handrail, 1 increase). (104 double handrails)
   3-6. Row: 104 double handrails
   7th Row: Change the color. Do 104 pins. You can cut the rope.
   Skirt Waist: You can make a belt by carrying a chain with a rope over the body.
2. You can also make the clothes hangers by pulling the chain so that it does not stand abundantly according to the size of your baby.